Cellphone-Mate Force-5 Przewodnik Instalacji

Force5-502G-3G-4G 5-Band WirelessAdjustable Cellular Booster KitUser GuideIntroductionInstallationPackages ContentsConguring Gain SettingIntroductio

1015 DB21 DB31 DBONONONONONONONOFFONONOFFONOFFONONTo Achieve...Set the DIP Switchs in the Same Bank as Follows...SW1(1 dB)0 DB1 DBOFFONOFFOFFOFFOFFOFF

11Automatic ShutdownSureCall boosters that have automatic shutdown work in the following way:1. The cellular side (LEDs 4 and 5) is usually the rst

12One of the red LEDs next to the dials on your signal booster is ashing red.Your signal booster restarted and shut down for 15 minutes, and is now s

13Product Name Force5-50 Uplink Frequency Range (MHz): 698-716 / 776 – 787 / 824-849 1850-1915 / 1710-1755 G Block Included 728-746 / 746 – 757 / 869-

14*All equivalent antennas and cables are suitable for use with the Force5-50 booster.Warning: Unauthorized antennas, cables, and/or coupling devices

15Three-Year Product WarrantySureCall warrants its products for three years from the date of purchase against defects in workmanship and/or materials.

16Limitations of Warranty, Damages and Liability:EXCEPT AS EXPRESSLY SET FORTH HEREIN, THERE ARE NO WARRANTIES, CONDITIONS, GUAR-ANTEES, OR REPRESENTA

17BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use o

2INTRODUCTIONThank you for your purchase of the Force5-50. The Force5-50 5-Band adjustable cellular signal booster removes the frustration over droppe

3INTRODUCTIONPackage Contents:Unpack all package contents, compare them against the package contents list, and check for damage. For missing or damage

4Quick Install GuideInstallationThe Force5-50 booster kit is specially designed for marine applications. It can also be used for other applications wi

5Option 21. When location of outside antenna has been determined, remove cap from ferrule side hole.2. Feed FME connector (small end) and cable thro

6Step 2. Using the SC-174 cableUse the SC-174 cable FME connector to connect the outside antenna to the boost connector marked OUTSIDE (see page 3).Ma

72. Using supplied plate, mark position of desired placement with a pencil or marker.3. Screw (not supplied) mounting plate into place with the slid

8Step 4. Install the Signal Booster1. Select a location close to a working AC outlet. Do not expose the signal booster to excessive heat, direct sunl

9Step 5. Congure Gain SettingsFacing the front of your booster, nd 9 banks of Dual In-line Package (DIP) switches. These switches allow manual dB ga